Second Hand Herman Miller Aeron Office Chairs
- Aeron Adjustments
Paddle-shaped lever on right side.
To raise: While taking your weight off chair, lift lever up.
To lower: While seated, lift lever up.
Goal: Adjust chair height so your feet rest flat on the floor or footrest with your body comfortably supported. Avoid
dangling legs, which puts pressure on and restricts the blood flow in the back of your thighs. You may need to adjust your desk or
keyboard height to make this work.
Long stem on right side, with knob.
To increase tension: While seated, turn knob forward (clockwise, toward plus [+] sign).
To decrease tension: While seated, turn knob backward (counterclockwise, toward minus [-] sign).
Goal: Increasing tilt tension gives you more stability and back
support when you lean back. How much tension you need in your
chair will depend on your body and your idea of whatís comfortable. People who carry more weight above their waists generally need
more resistance, people who carry more weight below their waists generally need less. Keep experimenting with it until itís
Wheel on base of arm support.
To raise or lower arms: For each arm, turn wheel upward until arm loosens. Grab the base of the arm support and raise or
lower it to the height you need. Turn wheel downward again to lock the arm in place. Repeat for the other side.
Goal: Adjust the height of each chair arm so the weight of your arms are supported. This helps take the weight off your
Front of each arm pad.
To swing arms in or out: While seated, grasp front end of arm pad and pivot it to the left or right.
Goal: Getting the arm angle just right helps support different types of work and shifts in posture. Swing chair arms inward
for support while using a keyboard. Swing them out when you use your mouse or another input device.
Thick pad on back of chair.
To adjust depth: Putting equal pressure on each end of the lumbar support pad, lift and push it out of its track in the back
of the chair. Flip it over and replace it in its track.
Goal: Notice that one side of the lumbar pad is thicker than the other side? Switch between thick and thin sides to find the
amount of lumbar padding that comfortably supports the natural curve of your particular spine.
Thick pad on back of chair.
To change height: Put equal pressure on each end of the lumbar support pad, and raise or lower it to a comfortable position
within the track.
Goal: Adjust it until it comfortably supports your back. Youíll know when youíve
got it right.
Front lever on left side.
To position chair forward: Lean back and lift the lever all the way up. Then lean forward with the lever lifted. Release the
To resume horizontal position: While seated, push lever all the way down. Lean back.
Goal: Many people who work on computers prefer a forward-tilting position. To support your back, set the tilt limiter after
switching to a forward position. If you work really long hours at a computer, you might try changing from horizontal to forward
position every couple of hours to keep your spine healthy and flexible.
Rear lever on left side.
To limit tilt range: Recline as far as you like. Move lever up to define the limit of recline. You can still move forward.
Readjust as necessary.
To release tilt limiter: Lean forward, press lever down.
Goal: If you want to sit in an upright position, set the tilt limiter when the seat is in a horizontal or forward position.